Home | Site Map | Cisco How To Net How To | Wireless | Search | Forums | Services | Setup Guide | Chicagotech MVP | About Us | Contact Us|

Bob Lin Photography services

Real Estate Photography services 
Routers

AT&T 2Wire Modem blocks all incoming traffics
Cable modem stops working randomly
Can't remote into LAN because two gateways in a network
Can't make change
Can't forward port

Can't make connect between a router to router VPN
DI-524UP DMZ doesn't work with no-ip
Error IKE[1] **Check your PFS setting ! from Linksys
Home network keeps losing connection
Issues of Dual WAN Router Configuration
Linksys router password was reset to default
Load Balancing Router
Losing to connect to the router after making some changes on the router or reset.
Netgear Firewall/VPN/Wireless Router lost wireless settings
Problem to configure WAN2 on DI-LB604
Router Common Issues
SBS connect to AT&T 2wire gateway
SBS RWW doesn't work after rebooting Comcast modem
This tunnel should not be initiator
Troubleshooting RTP300 Router for Vonage Phone
Wireless router behind another router can't access the Internet

Can't make change
Can't forward port

Symptoms: 1) I can make all changes except Virtual Server. If I make a change and apply, it comes back with empty settings on Virtual Server.
2. The port forwarding doesnít work but DMZ works.

Cause: the software not function. For consultants, refer to case 112304PH.

Can't make connect between a router to router VPN

Symptom: When creating a router to router VPN, the router shows disconnected but the log doesn't list any errors.

Cause:  incorrect Local Secure Group or Remote Secure Group. For consultants, refer to JO081204.

Error IKE[1] **Check your PFS setting ! from Linksys

Causes: Authentication, IKE, and pre-shared keys donít match. For consultants, refer to case 113004WA

Losing to connect to the router after making some changes on the router or reset.

Resolution: Re-set to default settings.

Router Common Issues

Symptom: You have setup tow Linksys routers as a gateway to gateway VPN. The both routers display the VPN "Connect". However, you can't ping the remote computer by name or ip, and the log doesn't list any errors.
2. PPTP doesn't pass through.

Causes: 1. Incorrected Secure Group settings.
2. Incorrected Dynamic Routing Mode.
3. Software no function.

For consultants, refer to case 112204CK

This tunnel should not be initiator

Symptom: when creating router to router VPN, you may receive error "This tunnel should not be initiator" in the log.

Cause: incorrect Local Secure Group or Remote Secure Group. For consultants, refer to JO081204

Post your questions, comments, feedbacks and suggestions

Related Topics

What's Dual WAN or Load Balance Router

A Dual WAN router or called Load Balance Router allows a router to use multiple paths to a destination when forwarding packets. With the ability to connect ...
www.howtonetworking.com/whatis/dualwanrouter1.htm 

Load Balancing Router

we simlply ran the wizard in which we set our 1mb link as wan1 and the 512 k as wan2 we assign them static Ip provided by isp at load option we set 70% for ...
www.chicagotech.net/netforums/viewtopic.php?t=1267

 

 

Bob Lin Photography services

Real Estate Photography services 

  This web is provided "AS IS" with no warranties.
Copyright © 2002-2017 ChicagoTech.net, All rights reserved. Unauthorized reproduction forbidden.