Sample of configuring Cisco 2955S switch

[chicagotech]

The Cisco Switch 2955 basic configuration will setup IP address, Subnet, Enable secret password, Enable password, and Telnet password. This is the sample.
Would you like to enter the initial configuration dialog? [yes/no]: Y (press Enter)

Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system.

Would you like to enter basic management setup? [yes/no]: Y (press Enter)

Enter host name [Switch]: chicagotech

Enter enable secret: switch

Enter enable password: cisco


Enter virtual terminal password: ms-mvps

Configure SNMP Network Management? [no]: n

Enter interface name used to connect to the
management network from the above interface summary: vlan1

Configuring interface vlan1:
Configure IP on this interface? [yes]: y
IP address for this interface: 10.0.20.51
Subnet mask for this interface [255.0.0.0]: 255.255.0.0

Would you like to enable as a cluster command switch? [yes/no]: n

The following configuration command script was created:
hostname host_name
enable secret 5 #3$Max7$Qgr2rXBhtcYJw4KK7ac650
enable password cisco
line vty 0 15 password ms-mvps
snmp-server community public
……

[0] Go to the IOS command prompt without saving this config.

[1] Return back to the setup without saving this config.

[2] Save this configuration to nvram and exit.

If you want to save the configuration and use it the next time the switch reboots,
save it in nonvolatile RAM (NVRAM) by selecting option 2.

Enter your selection [2]:2