Configure channel group in Cisco switch

[guest]

switch#conf t
Enter configuration commands, one per line. End with CNTL/Z.
switchconfig)#interf
switch(config)#interface range g0/46 , g0/48
switch(config-if-range)#channel-group 2 mode active
Creating a port-channel interface Port-channel 2
switch(config-if-range)#end
switch#conf t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)#int po2
switch(config-if)#switchport mode access
switch(config-if)#exit
switch(config)#exit
switch#sh etherchannel summary
Flags: D - down P - in port-channel
I - stand-alone s - suspended
H - Hot-standby (LACP only)
R - Layer3 S - Layer2
U - in use f - failed to allocate aggregator
u - unsuitable for bundling
w - waiting to be aggregated
d - default port


Number of channel-groups in use: 2
Number of aggregators: 2

Group Port-channel Protocol Ports
------+-------------+-----------+-----------------------------------------------
1 Po1(SU) - Gi0/37(P) Gi0/38(P)
2 Po2(SU) LACP Gi0/46(P) Gi0/48(P)